Setting The Timer; Fan Mode - DeLonghi PAC ES72 Bedienungsanleitung

DEHUMIDIFYING MODE
This is ideal for reducing humidity in the room (spring and au-
tumn, damp rooms, rainy periods, etc). For this type of use, the
appliance must be set up as for air conditioning mode. That is, the
air exhaust hose (B1) must be fitted to the appliance to allow the
humidity to be discharged outside.
To correctly set this mode:
Press repeatedly the MODE key (C2) until the dehumidify-
•
ing indicator (C10) appears.
• The available air flow is:
Automatic air flow: the appliance automatically
sets the best ventilation speed according to the envi-
ronmental conditions.
Note: in case of high humidity in the environment, it is possible
to discharge the condensate continuously by connecting a suit-
able hose to the upper drain connection (A11), allowing the
water to flow into a container. Make sure that the water does not
overflow onto the floor and that the drain hose is not blocked or
folded (Fig. 4).

FAN MODE

When using this mode, the air exhaust hose (B1) does not need
to be attached to the appliance.
To correctly set this mode:
• Press repeatedly the MODE (C2) key until the fan indicator
lights on.
• Pressing repeatedly the
flow is selected.
The available air flows are:
Minimum air flow: when most silent operation is
desired.
Maximum air flow: for maximum performance.
(C5) key till the desired air
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F. To change the tem-
perature unit of measure select the air conditioning mode then
press both the decrease
about 10 sec. The change of the unit of measurement is con-
firmed by an acoustic signal.

SETTING THE TIMER

The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimising
the operating periods.
How to program delayed shut down
• While the appliance is on in any operating mode, delayed
shut down can be programmed.
• Press the Timer button (C6): the timer indicator (C8) and
hours light up.
• Use buttons (C3) or
after which the appliance should shut down.
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer indicator stays
lit. At the pre-set time, the air conditioner goes into Standby.
To cancel the timer program, press the timer button (C6) twice.
The timer indicator (C8) will go off.
How to program delayed start up
• Set the appliance to standby.
• Press the timer button (C6): the timer symbol (C8) and
hours light up.
• Use buttons (C3) or
after which the appliance should start to operate.
• The appliance will start to operate in the same operating
mode that was previously set.
Start up can be programmed at any time within the 24 hours
that follow. A few seconds after the timer is set, the setting is
acquired. The timer indicator stays lit and the display returns to
standby.
To cancel the timer program, press the timer key (C6) twice. The
timer indicator (C8) will go off.
13
(C3) and increase (C4) keys for
(C4) to set the number of hours
(C4) to set the numbers of hours