DeLonghi Kyoto PLK130 Bedienungsanleitung Seite 37

Electrical connections
The terminal blocks on the units must be accessed to carry
out the electrical connections.
See the pictures at the side.
connection and for connecting the units together, see
the technical data table.
For the electrical connections, see the circuit diagram
inside the access flap and refer to the information
given in this manual.
The cable connecting the outdoor and indoor units
must be suitable for outdoor use.
The plug must be accessible also after the appliance
has been installed so that it can be pulled out if neces-
sary.
Installation of an omnipolar thermomagnetic line-dis-
connecting switch to CEI-EN standards (with contact
separation of at least 3 mm) near the appliance is
compulsory.
An efficient earth connection must be ensured.
If the power cable is damaged, it must be replaced by
an authorised Service Centre.
Under no circumstances should gas or water pipes be
used for earthing the appliance.
Upon completion of connections, secure the cables
with cable glands and replace the terminal block cov-
ers.
Failure to comply with these instructions and accident-
prevention regulations relieves the manufacturer from
all liability.
Blu
giallo-
Nero
Marrone verde
15