Assembly Of The Apron; Assembly Of The Seat Unit Fabric; Removal Of The Seat Unit Fabric - Emmaljunga NXT90 Anleitungen

Seat Unit
9.3 Press both of the buttons on each side of the frame to adjust the footrest.
Please Note! Maximum weight on the footrest is 3kg.
WARNING Never let your child stand on the footrest.

Assembly of the Apron

10.1 Pull the apron over the footrest.
10.2 Fasten the apron with the press stud on the inside of the hood.
Fasten the buttons at the back of the apron at the back of the hood frame.
Fasten the press stud that sits at the front of the apron on the front of the hood frame.
IMPORTANT!The hood cannot be folded down when the apron is permanently attached to the hood.
Open the zip in the middle of the apron when taking your child in or out of the pram.

Assembly of the Seat Unit Fabric

11.1 Place the seat unit fabric in the seat unit.
Thread the shoulder straps through the fabric. (see illustration)
WARNING It is important that the fabric is always correctly fitted. The seat unit should never be used without
fully fitting the seat unit fabric.
11.2 Thread the crotch strap through the seat fabric (see illustration).
11.3 Close the zip on the frame on the footrest and on the seat unit.
11.4 Press the studs together around the bumper bar.
WARNING The bumper bar should always be assembled when in use.
WARNING Always check before use that the bumper bar is firmly in place
WARNING Never carry the pram using the bumper bar.
11.5 Attach the hood into the frame
11.6 Attach the hood in place using the zip attached to the seat unit fabric.
Thread the arm pads through the harness.
11.7 IMPORTANT Turn the seat unit and make sure the zip is fastened around the bar on seat unit
WARNING Before you use the pram, check that the seat fabric is secure and that all the zips are firmly and
correctly in place.
WARNING It is important that the seat unit fabric is always fitted correctly.
WARNING Never use this product without fully assembling the seat unit fabrics onto the frame first.

Removal of the Seat Unit Fabric

12.1 Open the zip completely and remove the fabric from the seat.
If you only want to remove the seat fabric and not the hood, it is easier if the hood is in the extended position.
This is done by opening the upper zip on top
WARNING The hood must always be assembled when the pram is in use.
12.2 Open the zip on the seat unit and on the footrest.
12.3 Take out the harness straps through the holes in the fabric.
12.4 Take out the crotch strap completely from the fabric remove from the seat unit.
40
NXT 90 v 2.5