Assembly Of The Chassis; Assembly Of The Back Wheels; Assembly Of The Front Wheels; Folding The Chassis - Emmaljunga NXT90 Anleitungen

Chassis

Assembly of the Chassis

1
1.1 Unfolding the Chassis
1.2 Release the transport catch by releasing the grey clip.
To do this squeeze the chassis together.
WARNING There must not be a child in the pram when it is folded or unfolded
WARNING Avoid having children in the vicinity when the pram is folded or unfolded.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
1.3 Fold out the rear leg.
1.4 Press the "Press" label on the bar in the middle of the chassis until you hear a clear "click"
1.5 Make sure that you now see the closed padlock.
WARNING ALWAYS check before use that the chassis is locked.the closed padlock will be shown.
1.6 WARNING If the open padlock is visible, the chassis is NOT locked.
WARNING If the open padlock icon is visible, press down on the metal bar, the chassis locks and you will hear
'click'. Never use the stroller if the symbol with the open padlock is visible.
1.7 Pull out the telescopic handle.
1.8 Lock both grey clicks on the right and left of the handlebars. Make sure that the telescopic handlebar clips are
properly locked with a "click".
Make sure that the handlebar is at the same height on both sides before you lock into place.
WARNING Ensure that children are kept away from all moving parts if you adjust the pram to avoid risk of injury.
1.9 Adjust the handle by pressing the grey buttons on the outside of the handlebar. Make sure that they click into
position.
WARNING! Ensure that children are kept away from all moving parts if you adjust the pram to avoid risk of injury.

Assembly of the Back Wheels

2
2.1 Wipe dirt from the axles before you put on the wheels.
Press the button on the rear wheel. Insert the metal shaft axle in the rear wheel.
Ensure that the shaft clicks into the wheel
WARNING Check that the wheels are firmly fixed and cannot be pulled off the shaft.
2.2 Push the axle shaft into the chassis.
2.3 Lock the shaft with the grey lock that sits on the brake bar. The shaft shall click in locked position.
Check that the rear wheel is attached to the chassis properly by pulling the wheel. Repeat on both sides.
WARNING Check that the wheel is firmly fixed and can not be pulled from the chassis.
WARNING Avoid driving over sharp objects or sufaces eg. glass or the tyre can be punctured
WARNING To achieve optimum handling and to avoid punctures, air pressure should be correct. Please check
the air pressure at regular intervals (see marking on the tyre).

Assembly of the Front Wheels

3
3.1 Press in the button on the front section of the pram and push in the front wheel. Release the button and check
that the front wheel is attached to the chassis properly by pulling the wheel. Repeat on both sides.
3.2 This is how the chassis should look when fully assembled. (as illustrated in the picture).

Folding the Chassis

4
4.1 Take off the carrycot or the seat unit.
Turn the chassis so that the front wheels are pointing forward (as illustrated in the picture).
Make sure that the shopping basket is empty before folding the chassis.
WARNING There must not be a child in the pram when it is folded or unfolded.
WARNING Avoid having children in the vicinity when the pram is folded or unfolded.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
4.2 Adjust the handle in the low position.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
NXT 90 v 2.5
37