Christopeit Sport AL 4 Montage- Und Bedienungsanleitung Seite 20

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts are connected directly to the main
frame preassembled. In addition, there are several other individual parts
that have been attached to separate units. This will makes assembly
easier and quicker for you. Assembly time: 40 - 50 min.
Step 1:
Attach the stabilizer (59+86) at main frame (57).
1. Attach the front foot (86) with preassembled transportation roller (85) to
the main frame (57). Do this with screws M8x25 (99), washers (87) and
spring washers (14).
2. Attach the rear foot (59) with preassembled height adjustable caps (58)
to the main frame (57). Do this with screws M8x25 (99), washers (87)
and spring washers (14). After assembly has been complete, you can
compensate for minor irregularities in the floor by turning the wheel at
foot caps (58). The equipment should be set up that the equipment does
not move of its own accord during a training session.
3. Insert the rear plastic cover (45) into corresponding position on the side
covers.
Step 2:
Connection of cables (19+94) and assembly of support (92) at the main
frame (57).
1. Place screws M8x20 (56), curved washers (91) and spring washers (14)
accessibly beside the front part of the main frame (57).
2. Place the lower end of the support (92) against the main frame (57) and
push the support cover (89) with rubber ring (90) onto the support (92).
Plug the ends of the two computer cable harnesses (19+94) projecting
from (57+92) together.
(Note: The computer cable harness (19) projecting from the support (92)
must not slide into the tube, as it is required for later steps of installa-
tion.) When joining the tubes, ensure that the cable connection will not
trapped.
3. Put one spring washer (14) and one curved washer (91) on each screw
(56). Push the screws (56) through the holes in the support (92), screw
into the threaded holes of the main frame (57) and tighten lightly. (This
screw connection point will screw firmly at least in Step 4.)
Step 3:
Installation of the handgrips (6) with connecting tubes (16) at support
(92).
1. Push the axle (93) into the middle position at handlebar support (92) and
put one wave washer (5) and the connecting tube right (16R) onto the
right axles' end (93). Put on the screw M8x20 (13) a spring washer (14)
and a big washer 8//38 (15) and tighten it firmly. (Note: Right is specified
as viewed standing on the machine during training.)
2. Install the left connection tube (16L) incl. all additionally required parts
on the left hand side of the machine as described in 1.
3. Push the hand grips (6L+6R) onto the connecting tubes (16L+16R) and
adjust the holes in the tubes so that they are aligned.
(Note: the handgrip bars must be aligned after assembly so that the
upper ends are inclined outwards (away from the support (92)).
4. Push the bolt M8x20 (56) through the holes and tighten the handgrip
bars (6) with curved washers (91) and spring washers (14) at connection
tubes (16L+16R) firmly.
5. Connect the pulse connection cables (12) with pulse cables (11).
20
2 x