Installation Instructions - Volkswagen 1K0 054 630 C Montageanleitung

Installation instructions

Original parking distance control system, Touran 2011 ➤ and Jetta 2011 ➤
Scope of delivery:
◆
1 x controller
◆
1 x buzzer
◆
4 x sensor
◆
4 x covering rings
◆
4 x spacers
Required special tools, test equipment and auxiliary equipment:
◆
Torx driver bits (set)
◆
Flat-headed screwdriver
◆
Side cutters
◆
Hand drill
◆
Set of twist drills
Forstner bit ∅ 20
◆
◆
Crimp grip pliers
Installation process:
Note
◆
The original parking distance control system should be fitted by an authorised workshop. Incorrect fitting may lead
to damage to the vehicle or the parking distance control system.
◆
The original parking distance control system is not suitable for being fitted in vehicles with subsequent lowering
(sport suspension, etc.).
◆
The work to be performed described in these fitting instructions may change due to model servicing schedules.
For example, changes to the wiring colours or even the fitting sites should not be discounted. For this reason,
always consult the relevant up-to-date wiring diagram or the current vehicle repair manual.
◆
All rights to make technical changes reserved.
1.1 Painting the sensors
Note
◆
The sensors only require painting in the car colour when the bumpers are painted. If the bumpers are not painted,
the sensors do not require painting.
◆
Do not use a silicon remover to clean the sensors prior to painting, rather use a mild alcohol, e.g. methylated
spirits.
◆
When painting the sensors leave them in the packaging supplied, this is provided as a painting device.
◆
Additional general information concerning painting:

Self-study programme No. 214/215
Page 1 - Fig. 1
The figure gives an example of the protective rings -1- already placed in the correct position on the sensors -4-.

Place the covering rings -2- on the rubber membranes of the sensors -3-.

Paint the sensors -3- and -4- evenly and not too thickly in the same colour as the car.

Remove the covering rings -1- and -2- carefully directly after painting (while the paint is still wet) using tweezers
and let the paint dry.
Note
The protective rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.

Repaint as necessary after drying (e. g. clear lacquer for twin coat painting).
Component fitting, Jetta 2011 ➤, page 27
◆
1 x fixing material
◆
1 x power harness
◆
1 x sensor harness
◆
1 x installation instructions
◆
1 x operation manual
◆
Centre punch
◆
Triangular file
◆
Round file
◆
Tweezers
◆
Stanley knife
◆
-VAS 1978- wiring harness repair set
1K0 054 630 C
25