Connection To Power Supply; Footpedal Connection; Motor Connection; Operation - Nouvag TCM 3000 BL Bedienungsanleitung

TCM 3000 BL

4.1 Connection to power supply

Prior to connecting the mains cable to the mains socket, check the settings of the power supply next to
the main switch! If the displayed voltage does not agree with the local mains current, the grey fuse
socket must be adjusted to the correct voltage according to section 7.1. (Exchanging control unit
fuses)

4.2 Footpedal connection

The TCM 3000 BL is equipped with a footpedal. The footpedal cable can be plugged in and out on the
front side of the control unit at the footpedal connection.
Only the vario footpedal (cat. no.1471tcm) may be connected to the TCM 3000 BL!

4.3 Motor connection

The motor cable can be plugged in and out on the front side of the control unit at the motor cable
connection.
Only the electronic motor 31 ESS (cat. no.2064nou) or the electronic motor ENT
(cat. no. 2037nou) may be connected to the TCM 3000 BL

5.1 Switching on the TCM 3000 BL

The unit can be switched on and off with the main switch "I/O" at the mains connection located at the
back.
à à à à The display is illuminated.

5.2 Keyboard and display of the TCM 3000 BL

1
4
The device can now be operated!

5 Operation


LC display: - representation of set mode
"1:1"
"DTM"
"LIPO"
"THP"
"
"▼"
"▲"
"MOTOR"
- set rotational speed
- run-back
: Key mode 1:1
: Key mode Dermatome
: Key mode Liposuction
: Key mode Tattooing handpiece
" : Run-back key
: Key Reduce motor rotational
speed
: Key Increase motor rotational
speed
: Display Motor running
NOUVAG AG
No. 31739 35/05