Poor machine running characteristics
•
The machine is running but with no or insufficient sanding output
•
At low temperatures: Allow the machine to warm up to room temperature in a warm room.
•
Insufficient voltage: Check the conductor quality and length. Insufficiently dimensioned cable cross-
sections (strand dia. smaller than 2.5 sq.mm) and excessively long supply lines should be avoided, if
necessary use a transformer (e.g. product no. 708.00.00.100 for 230 Volts).
•
Check the tension of the V-belts and correct if necessary.
•
Check that the drive elements are not blocking or sticking.
•
Incorrect or blunt sanding material.
•
The machining is creating excessive noise and vibrations
•
Check the sanding drum for dirt deposits.
•
Check the sanding material for damage.
•
Check the belt drive.
•
Check the machine for blockages and deposits.
•
The machine is running well but creating dust
•
The dust bag is over-full.
•
The dust bag is not correctly mounted or damaged.
•
The sealing felt is damaged.
•
Check the suction system for blockages and clean if necessary.
•
The V-belt is damaged or not sufficiently tensioned.
•
The side cover is not mounted at the machine.
Sanding errors
•
Waviness, streaks, scratches
•
The sanding drum is damaged.
•
Incorrect sanding material used.
•
The wheels are soiled or damaged.
•
Driving elements or V-belt damaged.
•
The lowering rod linkage is running poorly, catching on something or getting stuck.
•
The machine setting is incorrect.
•
The operator is exerting the wrong sanding pressure.
•
Incorrect work method or work not correctly performed.
01.09.2008
Operating instructions
PROFIT
45