Output Circuit - Siko IV28M/1 Benutzerinformation

Output circuit OP/LD5/LD24 (12pole plug)
Pin Designation
A channel /B
B ---
C channel 0
D channel I
E channel A
F channel /A
G ---
H channel B
J ---
K GND
L ---
M +UB
4.3 Connection type E7 (5pole plug)
Output circuit PP
Pin Designation
1 GND
2 +UB
3 channel A
4 channell 0
5 channel B
4.4 Connection type E12 (6pole plug)
Output circuit PP
Pin Designation
1 GND
2 +UB
3 channel A
4 screening
5 channel B
6 channel 0
Counter-plugs and cable extensions available as
accessories from SIKO:
Mounting instructions for counter-plug for con-
nection type E6 (accessory)
1. Slip parts 6 to 10 over outer cable.
2. Strip cable.
3. Turn down screening.
4. Push part 5 onto ferrules.
5. Solder stranded wires at part 3 (follow connec-
tion diagram).
6. Open spacer (part 4) and put it over ferrules,
squeeze and push it onto part 3. Slot and keyway
of parts 3 and 4 must align.
IV28M/1 Datum 23.07.2008
7. Press parts 6 and 5 together; cut prodruding
screening.
8. Push parts 2 and 7 together and screw part 11
using appropriate tool.
9. Push part 8 into part 9 and slide both parts
into part 7.
10. Screw parts 10 and 7 together.
11. Push part 1 into part 2.
viewing side =
plug-in side
1 5
2
4
3
viewing side =
plug-in side
5. Commissioning
Please carefully read the information on the
encoder's mechanical and electrical connection.
This will ensure a trouble free commissioning and
operation.
Before operation, please check again:
• that the supply voltage's polarity is correct.
viewing side =
plug-in side
• correct connection of cable and signal lines
• secure encoder fixation
The encoder's and follower electronic's (eg. con-
trol unit) operating supply must be switched on
simultaneoulsy to avoid latch-up effects on the
encoder's outputs.
--> Now the encoder can be used.

6. Output circuit

PP
Art.Nr. 84362
screening
socket
pin
Änd. Stand 40/08
screening
7