Step 6. Connect The Power Cord - HP 9200c Kurzanleitung

Step 6. Connect the power cord

1. Connect the power cord to the product power cord connector. Then connect the power
This product can operate using either 110/120 volts (V), 60 hertz (Hz) power or 220/240 V,
NOTE
50 Hz power.
2. Turn the product on by using the power button. After the product warms up, a prompt
14 Chapter 2 Setup
cord to an adequate alternating current (ac) outlet.
appears asking you to configure your control-panel display language (see
Configure the control-panel settings).
Step 7.
ENWW