Installation; Functional Description - Makita AN510H Bedienungsanleitung

Never connect tool to compressed air line where
•
the maximum allowable pressure of tool cannot be
exceeded by 10 %. Make sure that the pressure
supplied by the compressed air system does not
exceed the maximum allowable pressure of the
fastener driving tool. Set the air pressure initially to
the lower value of the recommended allowable
pressure.
Do not attempt to keep the trigger contact element
•
depressed with tape or wire. Death or serious
injury may occur.
Always check contact element as instructed in this
•
manual. Nails may be driven accidentally if the
safety mechanism is not working correctly.
SAVE THESE INSTRUCTIONS.

INSTALLATION

Selecting compressor
(L/min)
120
100
80
60
40
20
0
0 20
Nailing frequency
009376
The air compressor must comply with the requirements
of EN60335-2-34.
The air compressor must comply with the requirements
of ANSI B19.3.
Select a compressor that has ample pressure and air
output to assure cost-efficient operation. The graph
shows the relation between nailing frequency, applicable
pressure and compressor air output.
Thus, for example, if nailing takes place at a rate of
approximately 60 times per minute at a compression of
1.77 MPa (17.7 bar), a compressor with an air output
over 40 liters/minute is required.
Pressure regulators must be used to limit air pressure to
the rated pressure of the tool where air supply pressure
exceeds the tool's rated pressure. Failure to do so may
result in serious injury to tool operator or persons in the
vicinity.
40 60 80 100
(times/min)
Selecting air hose
Fig.1
Use a high pressure resistant air hose.
Use an air hose as large and as short as possible to
assure continuous, efficient nailing operation.
CAUTION:
Low air output of the compressor, or a long or
•
smaller diameter air hose in relation to the nailing
frequency may cause a decrease in the driving
capability of the tool.
Lubrication
Fig.2
To insure maximum performance, install an air set (oiler,
regulator, air filter) as close as possible to the tool.
Adjust the oiler so that one drop of oil will be provided for
every 30 nails.
When an air set is not used, oil the tool with pneumatic
tool oil by placing 2 (two) or 3 (three) drops into the air
fitting. This should be done before and after use. For
proper lubrication, the tool must be fired a couple of
times after pneumatic tool oil is introduced.
Fig.3

FUNCTIONAL DESCRIPTION

CAUTION:
Always disconnect the air hose before adjusting or
•
checking function on the tool.
Adjusting the nailing depth
CAUTION:
Always disconnect the hose before adjusting the
•
depth of nailing.
Fig.4
Fig.5
If nails are driven too deep, turn the adjuster clockwise.
If nails are driven too shallow, turn the adjuster
counterclockwise.
The adjustable range is 0 - 6 mm. (One full turn allows
0.8 mm adjustment.)
Hook
CAUTION:
Always disconnect the hose when hanging the tool
•
using the hook.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
Fig.6
The hook is convenient for hanging the tool temporarily.
This hook can be installed on either side of the tool.
Install the hook on another side for installation and then
secure it with the screw.
7