Setting Up And Aligning The Appliance - hanseatic HSBS17990A1BK Gebrauchsanleitung

To prevent the formation of a flammable gas-
air mixture in the event of a leakage in the re-
frigeration circuit, the installation space must
have a minimum size of 9.5 m³.
Suitable locations are dry, well-ventilated ar-
eas that are cool if possible.
Unsuitable locations are ones with direct sun-
light or which are directly next to an oven, hob
or radiator.
The following minimum distances must be
maintained:
– from electrical hobs
– from oil and coal burning stoves
– from other cooling appliances
– from washing machines/dishwashers 10cm
If you would like to reduce these distances,
you can fit an insulation plate between the
appliances.
If underfloor heating is installed at the set-up
location, place the cooling appliance on an
insulation plate made from solid material.
The amount of energy used depends on the
location selected. The use of energy can in-
crease if the temperature is higher or lower
than the prescribed room temperature.
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure adequate air circulation,
– maintain a minimum distance of 10cm to
the rear wall.
– maintain a distance of 10cm on the
sides.
– free an area of at least 30cm above the
appliance.
3. Check the position with a spirit level.
10cm
30cm
10cm
4. Level out any unevenness on the ground
using the two front screw feet (28).
– Close the doors.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
– Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
PageGB-25
Start-up
(28)