Before Initial Use; Attaching The Immersion Blender (5) Or Whisk (6); Removing The Immersion Blender (5) Or Whisk (6) - Silvercrest SSSH 600 A1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SSSH 600 A1

6. Before initial use

Remove the SSSH 600 A1 hand-hand blender and all accessories from the packaging and check the
completeness of the delivery. Remove the protective film. Keep the packaging material away from children
and dispose of it in an environmentally-friendly manner.
Prior to using it for the first time, the hand-held blender must be cleaned as described in the "Cleaning"
section.
Assemble the hand-held blender once the cleaned parts have fully dried:
To use the whisk (6), this must initially be
placed in the adapter provided. Proceed as
follows:
Guide the shaft of the whisk (6) into the
adapter holder until the shaft audibly snaps
into place. Ensure that the two catches on the
shaft of the whisk (6) engage with the
corresponding recesses on the adapter.
An arrow marking () is attached to motor
block (4). On the immersion blender (5) and
whisk (6), the following markings are
attached: and .
These markings provide support when
attaching and removing the immersion blender
(5) or whisk (6).

6.1 Attaching the immersion blender (5) or whisk (6)


Attach the motor block (4) onto the immersion blender (5) or whisk (6) so that the arrow marking ()
points towards the opened padlock

Now rotate the motor block (4) so far in the direction of the closed padlock symbol so that the arrow
marking () points towards the closed padlock
that the immersion blender (5) or whisk (6) audibly snaps into place.

6.2 Removing the immersion blender (5) or whisk (6)


Rotate the motor block (4) so far in the direction of the open padlock symbol so that the arrow marking
() points towards the open padlock

Now remove the motor block (4) from the immersion blender (5) or whisk (6).
26 - English
on the immersion blender (5) or whisk (6). See figure B.
on the immersion blender (5) or whisk (6). Ensure
on the immersion blender (5) or whisk (6). See figure C.