Activation Of Air-Conditioning; Activation Of Heating; Heating Function; Air Conditioning Function - Gewiss Chorus GW 10 761 Bedienungsanleitung

The activation of the heating or air-conditioning functions are indicated as followed:
GENER L DESCRIPTION
The frostprotect function is only enabled in heating
function mode, when the thermal regulation system is OFF.
In this case the timer-thermostat uses the set
frostprotect temperature set-point, re-starting the
heating system only when the ambient temperature
decreases below T
The message "OFF" and the measured ambient
temperature are displayed on the screen.
The high-temperature protection function is only
enabled in air-conditioning mode, when the thermal
regulation system is OFF.
In this case the timer-thermostat uses the set high-
temperature set-point, re-starting the air-conditioning
system only when the ambient temperature exceeds the
T
HIGH TEMPERATURE PROTECTION
The message "OFF" and the measured ambient
temperature are displayed on the screen.
Heating
The symbol indicates that the activation command has
been sent to the actuator which controls the boiler. If the
timer-thermostat does not receive confirmation from the
actuator that the same has been activated, the
starts to flash. Subsequently, the timer-thermostat sends
the activation command again, at one minute intervals,
until it receives a positive response.
Air conditioning
The symbol indicates that the activation command has
been sent to the actuator which controls the air-
conditioner. If the timer-thermostat does not receive
confirmation from the actuator that the same has been
activated, the
timer-thermostat sends the activation command again, at
one minute intervals, until it receives a positive response.
43
.
FROSTPROTECT
.
symbol starts to flash. Subsequently, the
E
N
G
L
I
S
H
symbol