Safety Instructions For Maintenance; Operation - Husqvarna RA-V Bedienungsanweisung

8. Make sure that the blades and the cutting
attachment guard is not damaged. Replace
damaged parts.

Safety instructions for maintenance

WARNING: The cutting attachment can
continue to rotate after the throttle trigger
has been released. Remove the spark plug
cap from the spark plug. Make sure that the
The working technique
WARNING: Branches or grass can get
caught between the cutting attachment
guard and the cutting attachment. Always
stop the engine before you clean the cutting
attachment.
• Use full throttle when you cut and decrease to idle
speed after each cut.
CAUTION: Engine damage can occur if
the engine runs for too long at full throttle
without load.
Recommended use for the cutting
attachment
The cutting attachment blades moves with a small angle
and can cut in all directions. Move the cutting
attachment along the ground at a height where the
support cup touches the ground. Use the cutting
attachment to cut:
6
cutting attachment has stopped fully before
you do maintenance.
WARNING: The gear housing gets hot
during operation of the product. Hot surfaces
can burn you, do not touch the gear
housing.
• Always wear heavy-duty gloves when you repair the
cutting attachment. The cutting equipment is very
sharp and can easily cause cuts.
• Use only original spare parts for repairs.

Operation

• Park areas and road edges.
• Road side and near fences.
1051 - 001 - 18.04.2019