Expolite TourROD RGB MK2 Bedienungsanleitung Seite 23

Setting Slave Mode
MENU
SLAVE MODE
PERSON
In the menu SLAVE MODE the fixture can be set into the slave mode. In this mode the fixture is
controlled by a master unit on the same dmx-line.
Setting DMX Error Response
MENU
DMX STATE
PERSON
In the menu DMX STATE is set how the fixture responses if DMX-signal gets lost. Set DMX HOLD to
hold the last received value or BLACKOUT for blackout.
Setting Dimmer Speed
MENU
DMX CURVE PERSON
In the menu DMX CURVE different dimming speeds can be chosen for example to simulate a
halogen bulb. (CURV 1/CURV 2/CURV 3/CURV 4).
Miscellaneous Settings
MENU
PERSON SETUP
The default password is: DOWN - UP - DOWN - UP - ENTER
Dimmer ALL: limits the maximum brightness of the dimmer channel of the fixture.
BALANCE: possibility to do a (white) colour calibration. This can be done by setting the values (0 -
255) for Red (Dimmer RED), Green (Dimmer GREEN) and Blue (Dimmer BLUE).
HSIC SLAVE
DMX HOLD HSIC
BLACKOUT HSIC
HSIC CURV 1
HSIC CURV 2
HSIC CURV 3
HSIC CURV 4
Dimmer ALL HSIC 0 - 255 0 - 255
BALANCE
Dimmer RED 0 - 255
Dimmer GREEN
Dimmer BLUE
Key locks
HSIC OFF
ON
HSIC REMOTE OFF
ON
HSIC Display
30S
ON
HSIC RESET
****
REFRESH RATE HSIC 600HZ
1200HZ
4800HZ
9600HZ
Max temp
HSIC 30° - 70°
E-23
0 - 255
0 - 255
0 - 255