Attaching The Stand - Sharp LV-70X500E Bedienungsanleitung

Attaching the Stand

1
1
2
2
3
CAUTION
• Since this product is heavy, be sure that
it is unpacked and carried by at least
two people. Carrying it by yourself may
lead to injury.
• Use a commercially available screwdriver
and tighten the screws securely.
• When using an electric screwdriver, set the
tightening torque to 2.0 N·m (20 kgf·cm).
Assembly of the Stand Unit
1
Insert the stand supports (x 2) into
the positions (L/R) on the upper-side
cushioning material.
• Place the cushioning material as shown
in the illustration and insert L and R of
the stand supports correctly into L and
R positions of the cushioning material.
2
Use the longer M5 screws (16 mm
length) to fi x the stand and stand
supports.
1 Slide and remove the covers on the
bottom surface (x 2).
• Do not dispose of these covers as
they are to be used later.
2 Insert the stand supports into the
stand body and fi x them using the
mounting screws for stand support
(x 6).
3 Slide and attach the covers (x 2) that
have been removed in step 1.
• The assembly of the stand unit is
complete.
EN 2
1
Soft cushion
 Positions when holding the product
• When lifting or carrying, hold the product by the positions in the illustration, not by the stand or panel
surface.
Screws
Attaching Procedure of the
Stand
1 1 Insert the stand into the openings
on the bottom of the Monitor.
• Make sure that the stand is firmly
inserted into the Monitor. Improper
installation may result in tilting of the
Monitor set.
2 Insert and tighten the 4 screws
into the 4 holes on the rear of the
Monitor.
• In the installation procedure, be careful not
to catch your fingers between the Monitor
set and the floor.
• Do not remove the stand from the
Monitor unless using an optional wall
mount bracket to mount it.
• After attaching the stand to the
Monitor, do not hold the stand when
you put up, set up, move or lay down
the Monitor.