Supplied Components; Preparing The Remote Control Unit And The Touch Pen; Attaching The Holder - Sharp PN-L601B Installationsanleitung

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp: 2
 Power cord
 R-6 battery ("AA" size): 2
 CD-ROM (Utility Disk for Windows): 1
 Setup Manual (this manual): 1
 Stand hole protection cover: 2
* Sharp Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit and the Touch Pen

Installing the batteries
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (R-6 ("AA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
The touch pen, remote control unit, and eraser can be stored
in the holder.
Touch pen

Supplied Components

 Vertical sticker (Operation panel): 1
 Vertical sticker (Logo): 1
 Touch pen: 1
 Pen tip (for touch pen): 2
 Touch pen battery
(LR-03 ("AAA" size)): 1
 USB cable: 1
 Power switch: 1

Attaching the Holder

Remote control unit
and Eraser
 Eraser: 1
 Holder: 1 (With 2 hook and loop fasteners)
 Cover Sharp logo: 1
Place this sticker onto the SHARP logo to
cover the logo.
Inserting the battery
1. Rotate the battery cap and remove it, and then pull out the
cover.
2. Insert the supplied battery (LR-03 ("AAA" size)) in the
orientation shown, and attach the cover and battery cap.
1. Remove the peel-off sheets from the fasteners on the back
side of the holder.
2. With the holder spread taut, affix it to the side of the
monitor.
Battery cap
Back side
5
E