Removing The Temporary Stand And The Handles - Sharp PN-G655RE Bedienungsanleitung

Removing the Temporary Stand and the Handles

Removing the Temporary Stand
Prepare wall-hanging brackets or a stand to mount the monitor
unit. Read the manual for the brackets or stand for the proper
mounting procedure. (The screw holes for mounting brackets
(M10 x 4 holes) are provided on the rear of the monitor.)
Caution
• The monitor is heavy. Make sure to handle the monitor with
at least 3 people.
• This monitor is fixed to the temporary stand when shipped
from the factory. Please note that this stand is for temporary
use only until the monitor is properly mounted.
1. Hold the monitor with the handles to prevent it from falling
down, and remove the stand fixing screws (4).
Screws
2. Lift the monitor by holding it with the handles and the
underside of the unit.
3. When the installation is complete, attach the included stand
hole protection covers, using the supplied screws.
(1) Remove the screws from the monitor unit.
(2) Secure the stand hole protection covers with the screws
removed in step (1).
• The temporary stand is specifically designed for this
monitor. Do not use for other devices.
Removing the Handles
The handles are detachable.
After you removed the handles, be sure to replace the
removed screws in the original holes.
Screws
13
E