Castellini SKEMA 6 Übersetzung Der Originalbetriebsanleitung Seite 133

Turning on the camera's light (led).
Press the button to turn the camera's led lights on/off.
NOTE: icon ( A ) appears on the display to signal the leds have been
turned on.
• If necessary, adjust the brightness level by keeping pushed (at least 2 seconds)
the key and using the INCREASE and/or REDUCE keys to adjust it.
The set level is automatically saved.
NOTE: the value which can be entered ranges from 1 to 16.
Use the fast selection buttons to automatically set the following values:
- MAX button: level 16,
- MAX button: level 8,
- MIN button: level 1,
• To confi rm the intensity selected, exit this submenu by pressing the ESC
key.
"MIRROR" function.
When real images are displayed, press the button
mirror images.
This function is possible only in LIVE mode.
NOTE: the relevant icon (B) appears on the display to signal this
function has been activated.
"FREEZE" function.
This camera allows images to be frozen on the monitor.
This function can be activated in different ways:
• With the foot control ( see paragraph 5.2.).
• By tapping the touch button [ g ] on the camera's handpiece.
NOTE: the OSD control panel (see paragraph 5.8.1.) can be used
to select if the touch button [ g ] is to be activated or deactivated leaving
only operation with the foot control operative.
In order to go back to the "live" image, simply tap the button again or
actuate the foot control.
These images can be displayed in two different ways: single image or
multi image.
In the latter mode, the screen is divided into four parts and 4 frozen images
are displayed simultaneously.
SKEMA 6
- OPERATING INSTRUCTION
to change over to
GB EN 133 133 133