Basic Working Techniques - Husqvarna FS 500 E Bedienungsanweisung

1. Turn the cutting depth wheel until the cutting blade
slightly touches the ground.
2. Loosen the screw (A).
3. Set the indicator arrow to the position "0" (B).
4. Tighten the screw (A).
To align the pointer with the cutting
blade
Note: The pointer must be aligned with the cutting blade.
1. Put the inner flange along a line.
12
B
A
2. Lower the pointer and align the product with the
marks.
3. Align the pointer with the line.
4. If necessary, adjust the pointer until it is aligned with
the line.

Basic working techniques

WARNING: The blade shaft rotates when
the motor is started.
• Make sure that you always can push the machine
stop button during the operation.
• Make sure that no tools or other objects have been
left on the product.
• Do not go away from the product when the motor is
started.
• Make sure that the blade guard is attached correctly
before you start the product. Do not cut without the
blade guard.
• Do some marks that show where to cut before you
start the operation. Make sure there is no risk for the
operator or the product.
• Do not turn, rotate or move the product from side to
side while the cutting blade rotates.
• Tightly attach the concrete bricks before you cut.
The heavy weight of the material can cause damage
to the product and serious injury. Make sure that you
can move the product in controlled conditions.
• Make sure that there is always 1 more person near if
you use the product. If an accident occurs, you can
get help from that person.
• Do not go away from the product without the parking
brake engaged.
1024 - 001 - 04.06.2019