Klarstein Pasadena Handbuch Seite 30

EN
30
Lighting instructions
Warning
Danger of burning
Always test gas line for leaks at connector with soap water
finishing all connections.
Der Gasgrill verfügt über die folgenden Zündverfahren
1. 1. Connect the gas cylinder to the smoker following the instructions supplied with
the regulator.
2. 2. Turn all the control knobs to the 'OFF' position.
3. 3. Turn on the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. Check with the use of soap water for any
gas leakage between the bottle and the regulator and the gas valve. Any leakage
will show as bubbles in the area of the leak. If leak is found, do not use the smoker.
Consult your gas or smoker supplier for advice.
4. 4. To light burner, push down the control knob and keep pressing while turning anti-
clockwise to the "HI" position. Then press the "Ignitor" button to light the burner. If
not please repeat to press the "Ignitor" button.
• Should you have any difficulty lighting your gas grill following the above steps,
contact your dealer for advice.
• If the automatic ignition can't be used, please remove the cooking grill and heat
diffuser(hotplate ), and turn the valve anticlockwise to 90° Cto light with BBQ
lighter in the distance of 5mm to the burner fire hole. Replace the cooking grill and
heat diffuser (hotplate), please wear the fireproof and heat resisting gloves.
WarnIng
Danger of deflagration
If the burner still does not light ,turn the gas control knob to " OFF"
and wait for 2 minutes for the unburnt gas to evaporate before
lighting again.