Siemens KF... 86N Serie Gebrauchsanleitung Seite 38

en Installation and connection
Aligning the drawers
You can align the drawer vertically:
Open the drawer as far as it will go and remove the
1.
container.
Remove the middle screw on both sides.
2.
Note:
If you want to reset to the drawer factory
settings, retain the screws.
38
Loosen the upper screw on both sides.
3.
Note: Do not remove screws.
Lift the drawer and remove the lower screw on both
4.
sides.
Move the drawer upwards or downwards into the
5.
required position and screw the bottom screw into
one of the available holes.
Note:
The drawer can be adjusted by 1/16" (2 mm)
up and down.
Retighten all screws.
6.
To check the position, close the drawer and correct
7.
if necessary.