Status Values And Advanced Settings - Poolex NANO Turbo Installations- Und Gebrauchsanleitung

Current water
temperature
Useful information about how the heating mode operates
When the incoming water temperature is less than or equal to the required temperature (setpoint
temperature) -X°C, the heat pump will switch to heating mode. The compressor will stop when the
temperature of the incoming water is greater than or equal to the required temperature (setpoint
temperature).
Indicators for adjustment range X and Y
X : adjustable parameter from 1° to 15°C, default setting is 3°C. (Parameter N°6)
4.5

Status values and advanced settings

WARNING: This operation is used to assist servicing and future repairs.
The default settings should only be modified by an experienced professional person.
The system's settings can be checked and adjusted via the remote control by following these
steps
Step 1 : Keep pressing
Step 2 : Press and
Step 3 : Press to select the setting to be modified.
Note, some settings cannot be modified. Consult the settings table for further information.
Step 4 : Press and
Step 5 : Press to set the new value.
Step 6 : Press to return to the main screen.
18 | EN
4. use
Required
temperature
until you enter the settings verification mode.
for see the parameters.
to adjust the setting value.
Value 30 Parameter N°5