Removing, Cleaning And Fitting The Glass Panes - hanseatic 65M90D0-E11319G Gebrauchsanleitung

4. Pull the door slightly towards you and then
guide it forwards out of its hinges from below.
Putting the oven door back on its
hinges
1. Hold the door on an angle using both hands.
2. Place the hinges 21 on both sides in the
openings 22 in the side walls.
3. Open the door completely.
4. Fold the clips 20 on both sides all the way
back again.
You should now be able to close the oven
door so that it is level.
5. Close the oven door. If you hear a cracking
sound, the hinged clamps 20 are not pressed
Built-in oven with digital timer 65M90D0-E11319G
back far enough or the hinges 21 are tilted.
If this happens, remove the door from its
hinges and put it back on again.
Removing, cleaning and fitting
the glass panes
The oven door has three glass panes. You
should clean the panes and the gaps regularly.
Removing the glass panes
1. Pull the oven door off its hinges as described
in the section "Taking the door off and putting
it back on its hinges".
2. Lay the oven door flat on an even surface. It
is best to lay a woollen blanket or towel un-
derneath to avoid scratching the outer pane.
3. Take the inner pane out of the holder as
shown.
22
21
4. Also take the middle pane out of the holder
as shown.
General
G B - 2 9