Connect To 5.1 Channel Amplifier; Connect To An Amplifier With Digital Decoder - Seg DVRH6-160 Bedienungsanleitung

System Connection
Connected to 5.1 channel Amplifier
C SL
SW SR
5.1CH AUDIO OUT
Ordinary Cable 5.1 Channel
(Analog Output)
Connected to an amplifier with digital decoder
C
SW
5.1CH AUDIO OUT
Audio Source Cable
Amplifier
In Audio Setup, set the Digital Output Mode
Audio Output for reference).
When using a digital signal output (coaxial or optical), the Analog Output cable is not needed for connection.
12
The Rear Panel of the Unit
L Cb/Pb Y VIDEO VIDEO L
R Cr/Pr Coaxial
S-Video S-Video R
ANALOG AUDIO
VIDEO OUT DIGITAL OUT VIDEO OUT VIDEO I N SCART IN SCART OUT
OUT IN
Amplifier 1
The Rear Panel of the Unit
VIDEO
SL L Cb/Pb Y VIDEO L
Cr/Pr Coaxial
SR R S-Video S-Video R
ANALOG AUDIO
VIDEO OUT DIGITAL OUT VIDEO OUT VIDEO I N
OUT IN SCART IN SCART OUT
to LPCM Output (For details, see System Setup-Digital
System Setup
Record Quality
1. In the Recording Settings menu, use the
select the Default Quality item, and press the SELECT
button to drop down a menu.
IN
TV
2. Use the
OUT
ANTENNA the Select
3. Press the RETURN
menu and set up other items.
* For the differences of the six quality levels, SP, SP+, LP,
SLP, EP and HQ, see the glossary for reference.
APS(Auto program scan)
The unit has a channel tuner. You can receive TV signals directly from the unit. Before the tuning, you must
conduct a channel scan to enable the unit to tune in various channels automatically and determine their frequencies.
The tuned channels will be saved automatically. Even if the power is off, the saved channel information will not
be lost. Press the SETUP button to enter the System Setup mode. Use or button, highlight APS, select
it, and the following chart will show.
Confirm
Need stop current TimeShift before
AutoScan, and channel will be deleted.
OK to start auto scan, Cancel to exit.
OK
IN
TV
The meanings of the icons:
OUT
ANTENNA
1)press the or button to Select the APS
2) Press OK button, shows the right top chart. The tuner will start searching through various channel frequencies
and add available channels to the system memory. This procedure may take several minutes.
3)When the scan is complete,
of channels that have been stored to memory. Press the SETUP button on the remote control to exit.
Modify Channel
Use the or button to Select the Modify Channel
Modify channel information
Program Number
Name
Standard
Search Type
Band
Channel
Fine Tuning
Delete
OK
or button to
or button to select a desired value and press
button.
button to return to the upper level
Scan channels
CANCEL
item, as shown in the left top chart (if in TV channel state) .
TOTAL CHANNELS FOUND
item, in dialog chart select OK. As shown in the following chart .
Modify channel information
P003 Program Number
C h 0 3 4 Name
PAL 1 Standard
Channel Search Type
Standard
C - 3 4 Frequency
Fine Tuning
OK Delete
Cancel OK
SETUP MENU -RECORDING
Auto Chapter Marker Off
Record Quality SP
SP+
APS
LP
Modify Channel EP
1
SORT
Program Table
Timer Setting Menu OK
Country Selection Deutschland
2% 63.80MHz
0 channel (s) found.
STOP
will appear on the screen with the number
P003
C h 0 3 4
PAL 1
Frequency
607. 30MHz
OK
Cancel
41