Inhaltsverzeichnis
Werbung
Lubrication schedule
Intervals:
Monthly
¼ Annually
Maintenance and service instructions
Oil level control
1. Lower the lift completely
2. Remove the tank cap with integrated oil dipstick
3. Control the oil level on the oil dipstick
Oil change
1. Lower the lift completely
2. Remove the tank oil drain plug
3. Carefully Remove the tank oil drain plug screw and drain the oil in a suitable retainer
Clean with attention the oil tank and the oil filter to prevent a premature contaminate of the hydraulic oil.
4. After the completely oil draining seal the oil tank with the oil drain plug screw.
5. Fill the oil tank with new oil.
6. Raise and lower the lift and check if the maximum lifting height is still correct. Carefully refill, if necessary.
The used oil has to be disposed of in accordance with all legal and federal requirements.
Hydraulic system bleeding
1. For venting of the hydraulic circuit leave the Tank cap for the first 10 lifting movements opened.
2. Lower the lift completely and keep pressed the push button „DOWN „approximately 15 seconds so that the
hydraulic system will be completely de-aired.
® Urheberrecht ATH-Heinl GmbH & Co. KG, 2017, Alle Rechte vorbehalten. / Druckfehler und technische Änderungen vorbehalten / Stand: 07/2017
Components:
Lifting chain
Bolts from lifting chain
Slide ways
Synchronization ropes
Arm restraint device
Pulleys' bolts and safety notches
34
Oil or type of grease
Chain lubrication chain
Multi-purpose grease
Multi-purpose grease
Adhesive Grease
Greasing
Multi-purpose grease
Werbung
Inhaltsverzeichnis
