Inhaltsverzeichnis
Werbung
3. Installation & Setting of the locking catches
a. Bring all the locking catches like in the following drawing.
b. Make sure that the distance from the post to the lifting carriage (A1) and the distance between the post and
the locked safety notch (A2) are the same, if necessary can be adjusted the nut of the electromagnet..
c. Install the covers of the ectromagnets.
By installing of the covers for the electromagnets make sure that under the hexagonal head srews there
are installed the
waschers (6,4mm).
It the washers are forgotten, the screws will impede the corects lifting and lowering operation and will
protrude trought the columns.
Aftre the installing, check the inner side of the columns for a smooth sliding surface . (see pictures)
Insatalled washers
® Urheberrecht ATH-Heinl GmbH & Co. KG, 2017, Alle Rechte vorbehalten. / Druckfehler und technische Änderungen vorbehalten / Stand: 07/2017
Sliding surface
22
Werbung
Inhaltsverzeichnis
