Installing The Fuse - Toro Emotion Bedienungsanleitung

2. Slowly pour oil into the oil fill tube until the oil level
reaches the Full mark on the dipstick (Figure 8).
Do not overfill. (Max. fill: 0.59 l, type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Important: Change the engine oil after the first
5 operating hours ; change it yearly thereafter.
Refer to Changing the Engine Oil.
Figure 8
5

Installing the Fuse

No Parts Required
Procedure
Model 21027 only
Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you
install the fuse.
1. Open the battery cover (Figure 9).
1. Battery cover
2. Fuse holder
2. Locate the fuse holder from the upper left corner of
the opening to the battery compartment (Figure 9).
Note: The wire to the fuse holder is short; you will
not be able to pull the fuse holder fully out of the
battery compartment.
3. Install the fuse in the fuse holder (Figure 10).
7
Figure 9
3. Fuse