Problems Causes - Femi 2200 SPECIAL Gebrauchsanleitungen Und Wartung

• Differentiated disposal, to enable possible recycling
or environmentally compatible elimination of the
appliance, helps to limit undesirable effects on health
and the environment and promotes the reuse and/or
recycling of the materials which went into making up
the appliance.
7 TROUBLESHOOTING
PROBLEMS
Defective motor, power cable or
plug.
Blown electric panel fuses.
T h e m o t o r d o e s n o t
work.
No voltage in the mains system.
The overload cutout has tripped.
Motor overheating.
Motor overload caused by excessive
Overload cutout tripped.
cutting pressure.
Motor breakdown.
Inaccurate cutting angle
The setting of the D retainers (point
at 90° - 45° - 60°.
3.3) is inaccurate.
Excessive cutting pressure (on pipes
and section bars).
Inaccurate cut squaring.
Incorrect blade toothing in relation to
the piece to cut.
Incorrect adjustment of the eccentric
and sliding blade-guides.
Incorrect cutting speed in relation to
the piece to cut.
The piece is wrongly positioned in
the vice.
Cut finish is coarse or
The blade is worn or its toothing
corrugated.
is not right for the thickness of the
piece being cut.
T h e b l a d e t e n d s t o
Excessive cutting pressure.
p r o t r u d e f r o m t h e
Incorrect eccentric blade-guide
guides.
adjustment.
14
2200_PARTI COMUNI.indd 14 2200_PARTI COMUNI.indd 14
WARNING: Sanctions, in accordance with the
relative legislation in force in the country of use,
will be imposed on the user if the appliance is
disposed

PROBLEMS CAUSES

Specialized personnel should check the machine; do
not attempt to repair the motor by yourself.
Check fuse integrity and replace, if necessary.
Check for voltage in the mains system.
Release the run button and wait a few minutes for
the overload cutout to reset.
Check that motor air intakes are clear.
Perform the cut on the piece at the correct
pressure.
Specialized personnel should check the machine; do
not attempt to repair the machine by yourself.
Set the retainers by unloosening the fastening
screws and re-positioning them.
Decrease cutting pressure.
Check the cutting parameters (blade toothing, cutting
speed) in the cuts table (point 4.8).
Check blade-guide adjustment (points 3.5 and
3.6).
Check piece positioning and clamping in the vice
(point 4.6).
Check the cutting parameters (blade toothing, cutting
speed) in the cuts table (point 4.8).
Decrease cutting pressure.
Check eccentric blade-guide adjustment (point
3.6).
SOLUTIONS SUGGESTED
21/10/2008 15.27.43 21/10/2008 15.27.43