Cleaning And Care - Klarstein 10028185 Bedienungsanleitung

Installing a Continuous Drainage
If you are not intended to pour water in tank off frequently, a drainage pipe (with inner diameter of
9mm) can be connected on the back of this dehumidifier for drainage.
1. Find the position to block
the outlet on side. Shear
off the rib connecting the
plastic plate blocking the
outlet and dehumidifier
body and take it out.
Cleaning of PP Strainer
1. Pull out power plug before maintenance or re-
pair in case of electric shock.
2. Only PP strainer in this dehumidifier can be
cleaned.
3. If the strainer isn't very dirty, it's only required
sucking the surface with dust collector.
4. If the PP strainer is very dirty, please clean the
strainer with fresh or warm water, and the tem-
perature of warm water is approximate 40°C.
NOTE: To avoid deformation, the cleaned strainer should be put in dry air for natural drying and be far
away from any heat source. Please do not clean with chemical solvents such as alcohol or gasoline.
Cleaning and storing the dehumidifier
1. Please clean water tank or its cover with soft cloth dipped in cold water or warm water so as to
avoid mildew inside. If the dehumidifier is indeed very dirty, neutral cleaning agents can be used
to wipe.
2. After wiping, fix power line and entangle the whole dehumidifier with plastic bag of dehumidifier
body or other bags to avoid pollution by flying dust, etc. for use next time.
2. Connect one drainage
pipe in proper length to
the outlet firmly.

Cleaning and Care

3. Before use please check
the drainage pipe for so-
lid connection carefully in
order to avoid leakage of
water.
20