Klarstein 10028185 Bedienungsanleitung Seite 17

Auto Dehumidification
Initial startup of the dehumidifier defaults auto dehumidification
mode or select this mode via MODE. This mode can judge ope-
rating states in accordance with relative humidity in the room. In
addition the humidity can also be set up for dehumidification with
the setup range: 4 0 %-4 5 %-5 0 %-5 5 %-6 0 %-6 5 %-7 0 %,
which can be circularly selected. When the setup humidity is lower
than ambient humidity, the compressor starts for dehumidification.
Powerful dehumidification
Select this item, the compressor starts regardless of relative humidity indoor, and the fan forces to
operate by high-speed air for dehumidification.
Mild dehumidification
Select this item, the compressor starts regardless of relative humidity indoor, and the fan forces to
operate by low-speed air for dehumidification.
NOTE: In the above three dehumidification modes, if the air purification pattern (two small trees)
flickers, it is not fault, but the strainer (HEPA or activated carbon) is not removed, and air purifying
function is performed with dehumidification. If the HEPA or activated carbon strainer is removed, the
strainer pattern displays no strainer.
Ventilation function
To operate this mode, first remove the HEPA or activated carbon strainer, if
not, the strainer pattern flickers to remind the user of removing the HEPA or
activated carbon strainer. In order to guarantee service life of the HEPA strai-
ner or activated carbon strainer, removal is recommended. When it is humid
and clothes are not easy to dry, operate in powerful dehumidification mode
and press SWING, enabling auto swing of air swing blades to enlarge air
supply range and effectively feed dry air to each corner for faster and more
effective drying of clothes.
Internal drying mode
Touch DRYING for over 2s to start internal drying process, which
requires approximate one hour: Supply air (high-speed) operati-
on lasts about 30min; the dehumidifier continues high-speed air
operation and air guide blades sweep air at wide angle for about
10min; and then the dehumidifier continues high-speed air ope-
ration and air guide blades return to fixed position and continue
operation for approximate 15min.
To stop the drying mode press DRYING again for over 2s to cancel internal drying function and re-
turn to running status before startup of drying; press POWER to stop internal drying and recover
standby.
17