Operating; Led Indication - Honeywell Accentic Montage- Und Bedienungsanleitung

26
9.

Operating

9.1 Correct application of data carriers
Due to the position of the transmission/reception antenna inside the different data carriers, a
different read position of the data carrier is required to the operating unit. The data carrier should
be held approximately in the
X
Correct
9.2

LED indication

The LEDs and the buzzer are controlled over a bus system. The definition for each is specified in the
main software and not at the reader.
At readers with Clock/Data interface the yellow LED lights permanently and can not be switched off.
At readers with RS-485 interface the yellow LED can be switched dark via software.
green
yellow
red
Mounting and Operating
of this range.
middle
IK data carrier
card
Incorrect
Color Basic
condition
yellow on
yellow off
green on
red on
green
red
red
Instructions - proX2-reader "Accentic" without keypad
IK data carrier
key fob
Influence on the read process by other data
carriers:
In order to prevent several data carriers affecting
the read process, ensure that the desired data
carrier is held separately, if possible, in the
reading range.
After reading
a card or after
a keystroke
Operation / ready to read
Device is idle
PIN-Code or door code entry is active
(only possible with RS-485 interface)
Permanently released
Permanently blocked
on Door release
on ID card not authorized
blinking Read error
IK data carrier
watch
Meaning