Activate Address Allocation Mode; Address Indication; Manual Address Allocation Via Central Control Unit - Honeywell Accentic Montage- Und Bedienungsanleitung

22
6.2.2

Activate address allocation mode

In NetEdit, the address allocation mode is
preselected and the reader informed via the ACS-8.
The address allocation mode at the
indicated by the bottom flashing green LED (lights
up briefly followed by a long pause
Switch off the address allocation mode in NetEdit.
6.2.3

Address indication

The address allocation mode must be activated.
The address indicator is for monitoring newly defined
addresses or for a later control.
- Tens digit: Upper LED
Each flash indicates the tens digit of the allocated
address.
Example: Flashes 2 x = 20
- Units digit: Middle LED
Each flash indicates the ones digit of the allocated address.
Example: Flashes 4 x = 4
The address allocation mode is then displayed in the lower LED.
Repeat display of addresses:
Hold the transponder briefly in the reading range of the reader. A brief acoustical acknowledgement
confirms the request to display and restarts the display sequence. The bottom LED remains dark when
the address is displayed.
6.2.4 Manual address allocation via NetEdit
Enter the unique number (serial number) of a new reader plus the desired address when
programming NetEdit and transmit to the ACS-8. The ACS-8 transmits the unique number plus the
address to the reader. If the received unique number corresponds with the number defined in the
reader, the reader stores the address.
Address acknowledgement: After approx. 1 sec., the LEDs indicate the newly allocated address
(see 6.2.3).
Programming
NetEdit
Enter unique
number
plus address
Mounting and Operating
).
(green)
(yellow)
Unique number
address
+
Instructions - proX2-reader "Accentic" without keypad
reader is
Unique number
address
+
ACS-8
Address allocation
mode indicator
Tens digit (green)
Units digit (yellow)
This example shows address 24