Mounting Guidelines - Honeywell Accentic Montage- Und Bedienungsanleitung

Mounting and Operating
4.2

Mounting guidelines

The reader is suitable for indoor and outdoor use. It can be mounted directly on the wall or via a
"standard f.m. socket". The electronic unit is inserted in the back of the housing and locked into
position with the replaceable housing front.
For mounting surfaces of metal, the transmission range of the transponder may be lower
than that of non-metallic surfaces.
In order to read the LED indicators
When used outdoors, do not expose the reader directly to the weather!
If necessary, use the plastic housing (weather/view) Item no. 023501.
To mount, lift the housing front at the bottom and unhook at the top. When mounting the housing
back, remove the electronics to avoid damage.
The housing back has two 60 mm boreholes for wall and f.m. sockets. To fix securely, use screws
that are suitable for the mounting surface..
- In masonry with S6 plug:
- In wood, depending on type : Semi-circular wood screw with slot 3.5 x 45 mm to 3.5 x 60 mm
- In metal:
- On the standard s.m. socket Semi-circular wood screw with slot 3.0 x 40 mm and washer
For additional fixing, the third borehole can be used (see 4.1). Choose the correct screw length for
the mounting surface.
When mounting, feed the cable, if possible, from the back through an empty pipe allowing sufficient
spare cable.
Attention!
If the reader is to be used outdoors,
the cable bushing must be sealed
of the wall, (e.g. with
both sides
plaster to prevent condensation
)
from forming!
When mounting on an f.m. socket or
on a cavity wall, install the socket so
that the fixing holes are horizontal
(see illustration).
To close the housing press in one of the enclosed
seals in the middle. The housing cannot be opened
without destroying the seal.
Instructions - proX2-reader "Accentic" without keypad
optimally , mount the
E.g. semi-circular wood screw with slot 3.5 x 60 mm
Fillister head screw
on
reader
130 to 140 cm
M3 x 30 mm (min.) with washer
Fixing holes
60 mm
Observe notches
19
above the floor.