Connecting The Speakers; Cable Lengths & Cross Sections - Revox Re:sound G Mini Bedienungsanleitung

Mini

Connecting the speakers

Important
Before cabling, disconnect your
hi-fi system (amplifier, receiver,
power amplifier etc.) from the
mains.
Connect the speaker outputs A
or B on the back of your
amplifier to the corresponding
terminal screws
speakers, using speaker cables
with bared ends. You must be
careful to keep the correct
polarity in order to ensure
perfect sound reproduction.
Connect the positive pole of
the amplifier to the positive
pole of the speaker.
Crossed polarity doesn't cause
any damage to the speaker or
the amplifier, but it leads to an
imprecise bass and a somewhat
diffused sound
on the
picture.
15
Cable lengths
sections
Revox speakers
consistent electrical phase and
impedance characteristics and
are an uncritical load for the
power amplifier and the speaker
cables.
Your specialist dealer offers
speaker cables
styles and with various cross
sections. He will be glad to
advise you according to your
individual needs.
In order to keep cable loss as
low as possible, we suggest the
following cable cross section
dimensioning scheme:
Cable length
up to 10 m / 33 ft 1.5 mm
over 10 m / 33 ft 2.5 mm
We advise against using long
cables (more than 30 m / 100
feet) because of inevitable loss.
Re:sound
& cross
have
in different
Dimension
2
/ AWG15
2
/ AWG13