Connecting The Loudspeakers - Revox Re:sound C32 Bedienungsanleitung

C32 / C95
Putting your speakers up against a
wall or in a corner will probably
reinforce the bass too much. This
effect will be increased in lightly
furnished rooms as they can hardly
absorb bass frequencies.
The low frequency behavior may be
controlled by the distance of the
speakers to the walls. According to
the acoustic actualities of your living
room very serious changes of the
bass volume can occur between the
possibilities ''larger distance (slim
bass)'' and ''in the angle of the room
(beefy bass)''. Hence it is to be
recommended to locate the best
tonal balance by
speakers inch by inch.
Leave at least 40 cm (15 in.) of space
between the speakers and any
nearby wall. These speakers are
designed for vertical operation. A
''lining-up '' of the speakers to the
listening point can
advantageous acoustic effect as
thereby reflections at the adjoining
room walls are reduced.

Connecting the loudspeakers

Connect the loudspeaker outputs A
or B on the back of your amplifier to
the corresponding terminal screws
on the speakers, using loudspeaker
cables with bared ends. Watch the
polarity:
shifting the
Please note:
If one or even more speakers are
connected with the wrong polarity,
there is a significant reduction in the
bass reproduction and the sound
portrait is uneven and diffused.
have an
11
Important
Before cabling disconnect your
hi-fi system (amplifier, receiver,
power amplifier etc.) from the
mains !
amplifier - Ioudspeaker
amplifier - Ioudspeaker
Re:sound C