Day /Night; Sync; Cam. Id - Monacor SECURITY TVCCD-187HCOL Bedienungsanleitung

GB 6.8.2 DAY/ NIGHT
COLOR permanent colour mode, IR suppression filter activated
permanent black-and-white mode, IR suppression filter deacti-
BW
vated
AUTO automatic switchover between day mode (colour mode) and
night mode (B / W mode) depending on the ambient light: When
darkness falls, the camera will switch over to B / W reproduction
and the IR suppression filter will be removed mechanically;
with sufficient lighting, the IR suppression filter will return to its
position in front of the CCD chip and the camera will switch
back to colour reproduction. The delay time for switchover will
be 3 to 4 seconds.

6.8.3 SYNC

If the camera is supplied with power via a 50 Hz AC voltage, the type
of image synchronization will be adjustable.
internal synchronization (image synchronization via an internal
INT
pulse generator); standard setting for displaying the image of
this camera only on the monitor connected
line lock (image synchronization via the mains frequency);
LL↵
when several cameras are used (e. g. for systems with camera
switchers), line lock will allow to synchronize the video signals
of these cameras to prevent the images from rolling vertically
when switching between cameras
In the submenu, the phase of the video signal will be corrected
via the value PHASE, e. g. for synchronizing the camera with
another camera not supplied with power from the same phase
of the mains.
With a DC power supply, the fixed setting of the camera will be INT.

6.8.4 CAM. ID

For remote control of focus and zoom settings via the RS-485 interface
(connection
menu CAMERA ID: In the line ID NUM, assign an identification number
(0 – 255) to the camera to allow addressing in the surveillance system,
28
Note: If the camera is set to AUTO mode when there is a powerful IR light
flickering erratically, malfunctions of the IR suppression filter may occur.
chapter 5.1), make the required settings in the sub-