Maintenance; Handle With Care; Cleanliness; Batteries Of The Display Unit - SKF TKSA 40 Bedienungsanleitung

7. Maintenance

7.1 Handle with care

The measuring units are equipped with sensitive electronic and optical parts.
Handle them with care.

7.2 Cleanliness

For best function the system should be kept clean. The optics near the laser and detector
should be free of finger marks. If necessary clean with cotton cloth. The hard plastic
window should not be cleaned with alcohol, thinner, gasoline, or other volatile organic
solvents or with chemical detergents.

7.3 Batteries of the display unit

The display unit is powered by two LR14 (C) batteries. Most LR14 (C) batteries can be
used, but alkaline batteries have the longest life. If not using the system for a long period,
remove the batteries from the display unit. Flat batteries will be indicated by the battery
signal on the display.

7.4 Replacement of measuring units or display unit

Both measuring units are calibrated in pairs and hence they must be replaced as a Pair.

7.5 Software upgrade

The software of the TKSA 40 can be upgraded through the connection to a PC with the
USB cable. Information about software upgrade will be sent to registered users (see 2.3)

7.6 Spare parts and accessories

Designation Description
TKSA 40-DU Display unit (TKSA 40 system)
TKSA-MU Set of measuring units Movable and Stationary
(TKSA and TMEA 2 system)
TMEA C1 Locking chains, set (500 mm) + tightening tool
TMEA C2 Extension chains set (1020 mm)
TMEA F2 1 chain fixture, complete
TMEA F7 Set with 3 pairs of connection rods (short: 150 mm,
standard: 220 mm, long: 320 mm)
TMAS 340 Complete kit of 340 pre-cut machinery shims
TMAS 360 Complete kit of 360 pre-cut machinery shims
TMAS 510 Complete kit of 510 pre-cut machinery shims
TMAS 720 Complete kit of 720 pre-cut machinery shims
32 SKF TKSA 40