Enter The Dimensions - SKF TKSA 40 Bedienungsanleitung

3.4 Enter the dimensions

Distance
between the
measuring
units (MU)
Fig. 12. Entering dimensions screen
Use the tape measure provided to measure the distances indicated on the screen.
Navigate to the different distance fields with the left/right selection arrows.
Enter the values using the alphanumeric keyboard.
The measurement needs to be entered, in millimeter or inches depending on the
measurement system used (see section 4, settings).
Confirm with OK or with the right selection arrow.
Erase the content of a box with the C key.
The rotational speed (RPM, rotation per minute) can be entered directly in the required
field. Enter the RPM and press OK to confirm.
Otherwise, press OK on the rotational speed field to display the built-in recommended
maximum acceptable misalignment table.
This table is used (as a reference) for the automatic tolerance check function of the TKSA
40. It is to be used as a guideline only.
It shouldn't replace the original equipment manufacturer recommendations.
These recommendations can be entered in the editable fields at the bottom of the table.
SKF TKSA 40
MU marked "S"
raw value
Distance Distance
between the between the MU
centre of the marked "M" and
coupling and the front feet of
the MU marked the moveable
"M" machine
MU marked "M"
raw value
Distance
between
the front and
rear feet of
the moveable
machine
Measurement
module
Soft foot
mode
Settings menu
File manager
Low battery sign
Measurement
unit
Rotational
speed of the
motor
C
13