Display The Results - SKF TKSA 40 Bedienungsanleitung

3.6 Display the results

After the measurements are performed, the results are displayed on the screen.
The results can then be saved in the internal memory of the unit (see section 3.7), in
order to be displayed afterwards on the display unit or copied to a computer via the
provided USB cable.
Main display of the results:
Indication of the alignment status compared with the maximum acceptable misalignment value
{
Coupling
values
Angular
Parallel/ offset
{
Feet
adjustment
values
Fig. 17 Results screen display with all dimensions entered
The coupling and feet adjustment values are displayed for both vertical and horizontal
planes.
The unit automatically compares the coupling values with the maximum accepted
misalignment given in the section 3.4, and displays the status of the alignment compared
to this value. The result is interpreted according to the table below:
OK. Within the maximum acceptable misalignment values
NOT OK. Within double the maximum acceptable misalignment values
NOT OK. Out of double the maximum acceptable misalignment values
SKF TKSA 40
Vertical
Adding /
modifying
dimensions
Horizontal
Adjustment
module
Measurement
module
Soft foot mode
Save results
File manager
17