Cleaning And Care - Klarstein 10029177 Bedienungsanleitung

Filling
• Open the lid and fill the kettle via the lid aperture.
• Watch the level in the water level indicator. The water level must be below the max mark.
• Do not overfill the kettle. If the kettle is overfilled, there is a risk that boiling water may be ejected.
• Replace the lid and press it down. Check that it is fully closed; otherwise the kettle may not switch
off when it boils.
Switching on
• Check that the switch is in the "OFF" position (lifts the kettle from the power base and set it down again).
• Plug the power base into the wall socket. If necessary, switch the socket on. Gently position the
kettle on the power base, taking care not to spill any water.
• Press the switch down. The switch will light up, and the kettle will start to heat up.
• When the water has boiled the kettle will switch off automatically, the switch will return to the
"OFF" position and the light will go out.
Switching off
If you need to switch the kettle off at any time before the water boils, simply lift it front the power
base and set it down again. The switch will pop up, into the "OFF" position
General Hints on Use
• When you lift the kettle from the base, you may see moisture on the surface of the base. This is the
steam used to switch the kettle off automatically, which then condenses and is allowed to escape
via vents in the underside of the kettle, do not lift it backwards, as this may allow water to pass
through the steam aperture on to the control area. Should this occur, the kettle must be allowed
to dry before use.
• To avoid the risk of splashing, pour slowly and do not over-tilt the kettle.
• Do not switch the kettle on unless it contains at least one cup of water. Misuse of this kind will
shorten the life of the element.
• If the kettle is accidentally switched on when it does not contain sufficient water, a boil-dry device
will automatically switch it off. Wait until the kettle has cooled down before filling, as the element
will be hot and spitting may occur
Cleaning
• Switch the kettle off (lift it from the power base), unplug the power base from the wall socket and
let the kettle cool down completely before cleaning.
• Wash the outside and inside surfaces of the kettle with a damp cloth. If necessary, you may use a
little household detergent. To clean the filter, see "Water filter" below. If you use detergent inside
the kettle, rinse thoroughly afterwards to remove all trace if the detergent.
• Ensure that all connectors and sockets are kept dry. Do not immerse the kettle or power base in
water or any other liquid. Do not use harsh or abrasive cleaners or solvents.
Decaling
Scale build-up will cause the element to overheat, reducing its working life. It may also cause the
safety cut out to operate prematurely, switching the kettle off before the water boils As the element is
mounted beneath the kettle, there are no awkward nooks and crannies for the scale to get a foothold.
It can build up only on the walls and floor of the kettle, where it can be seen and dealt with. To mi-
nimize scale build-up:
• Empty the kettle after each use; do not allow water to stand in the kettle overnight; use filtered
water instead of ordinary tap water.

Cleaning and Care

8