Input Mode - Siko MA01/1 Benutzerinformation

system. This value is set by
referencing the system according
to chapter 12.
_oFF_ Offset: Can be any value; used to
influence the value displayed, eg.
tool correction value.
_dP_ Decimal point (only available if
'Resolution' has been programmed
to 'FrEI' before): Determination of
the decimal point according to the
resolution.
_dIr_ Counting direction of the measu-
ring system: depends on the
sensor's mounting position and
can be changed subsequently.
"UP" Upward
"dn" Downward
_dI_E Display mode of the sensor inputs
(only in case of a 2-channel MA01/1).
"CH Add" Calculation (with sign) of the
sensor values accord. to the
following formula :
Display = CH1 + CH2 + Off1 + Ref1
If resolution is programmed as
"FrEE":
Display = (CH1 + CH2) x Fac +
Off1 + Ref1
"CH" single display
_A_SEn Automatic channel switching (only
in case of a 2-channel MA01/1 and
"single display").
"AUS" ineffective, only manual switching
is possible
"EIn" effective, and additional manual
switching is possible
_AUto_ Switch-off method: State of the
automatic switch-off:
"0" 0 = no switch-off.
"1" 1 = stand-by-mode
"2" 2 = sleep mode
(always after the switch-off time
programmed under 'PErIod')
PErIod Switch-off time (s): Time since last
measurement / sensor move after
which the display will pass to
stand-by or sleep mode.
_rSTo__ Last value memory:
"oFF" Last value memory off. When
switched on, the display must be
calibrated (zeroed).
"on" Last value memory on. When
switched on, the last measured
MA01/1 Datum 16.11.2001
_F_AbS Access reset function: resetting to
"oFF"
"on"
_F_rEL
"oFF"
"on"
_F_rEF
"oFF"
"on"
_F_OFF Access offset value: to enter /
"oFF"
"on"
_LAn_
"d"
"E"

9. Input mode

Reset function
• Press key
reference value.
• In the 2-channel MA01/1 version this function
is always active and cannot be switched off.
Incremental measurement function
for 2-channel version of MA01/1:
• Press the two arrow keys
ously to activate incremental measurement
function
• The display is zeroed. A special indicator
signals that incremental measurement function
is activated.
• Press the two arrow keys again to deactivate
incremental measurement function and to return
to the display of the absolute dimension.
for 2-channel version of MA01/1:
• Press key
rement function.
Art.Nr. 77320 Z.Nr. 8664054
value is displayed.
reference value via key
of the display.
( in case of 2-channel MA01/1always "on")
Reset function off
Reset function on
Access incremental measurement:
to switch from absolute dimension
and zero-setting to subsequent
relative dimension
Increm. meas. function off
Increm. meas. function on
Access reference value: to enter /
change reference value
( only in case of 1-channel MA01/1)
Reference value function off
Reference value function on
change offset value
( only in case of 1-channel MA01/1)
Offset value function off
Offset value function on
Language: to choose the language
in which the menu points are to be
displayed
German
English
to set the display to the
+
to activate incremental measu-
Änd.Stand 389/01
on front
simultane-
1 3