Installation - Siko MA01/1 Benutzerinformation

User Information
MA01/1
Electronic Display
TGL
ENGLISH
1. Warranty information
In order to carry out installation correctly, we
strongly recommend this document is read very
carefully. This will ensure your own safety and
the operating reliability of the device.
• Your device has been quality controlled, te-
sted and is ready for use. Please respect all
warnings and information which are marked
either directly on the device or in this document.
• Warranty can only be claimed for components
supplied by SIKO GmbH. If electronic display
MA01/1 is used together with other products,
there is no warranty for the complete system.
• Repairs should be carried out only at our
works. If any information is missing or unclear,
please contact the SIKO sales staff.
2. Identification
Please check particular type of unit and type
number from the identification plate. Type num-
ber and the corresponding version are indicated
in the delivery documentation.
e.g. MA01/1-0023
MA01/1 Datum 16.11.2001
ON
OFF
EG60
ON
OFF
version number
type of unit
Art.Nr. 77320

3. Installation

For mounting, the degree of protection specified
must be observed. If necessary, protect the unit
against environmental influences such as
sprayed water, dust, knocks, extreme tempera-
tures.
Mounting of the display
Below are the dimensions for panel mounting:
Cut-out in control panel
Fig. 1: Panel mounting
EG60: Push device into panel (3) until the panel
clips (1) hold the housing loosely. Press the
lateral centering (2) slightly down and push the
housing into the cut-out until the panel clips snap
completely.
Fig. 2: Sketch to show mounting EG60
EG30: Push device into panel (3). Tighten brak-
ket screw on the rear (2). Align device on front
plate and tighten screw.
Z.Nr. 8664054 Änd.Stand 389/01 9