Lenze Drive PLC Montageanleitung Seite 50

Show/Hide Bookmarks
?
Troubleshooting and fault elimination
Display Fault
1)
Keypad PC
63 Communication error to
C C C C E E E E 2 2 2 2
CAN-IN2
64
Communication error to
C C C C E E E E 3 3 3 3
CAN-IN1 with event or time control
65 BUS-OFF
C C C C E E E E 4 4 4 4
(many communication errors
occurred)
91 External fault (TRIP-Set)
E E E E E E E E r r r r
105 Internal fault
H H H H 0 0 0 0 5 5 5 5
108 Error when configuring the
H H H H 0 0 0 0 8 8 8 8
Extension Board
74 Fault in program execution
P P P P E E E E r r r r
79 Initialisation error during transfer of
p p p p i i i i
parameter set
75 Internal fault
P P P P R R R R 0 0 0 0
72 Faulty transfer of PAR1 with
P P P P R R R R 1 1 1 1
keypad/PC
79 Internal fault
P P P P r r r r 5 5 5 5
1)
LECOM error number
50
Cause
CAN-IN2-object receives faulty data
or communication is interrupted
CAN-IN1-object receives faulty data
or communication is interrupted
The Drive PLC has received too
many incorrect telegrams via the
system bus and has been
disconnected
A digital signal assigned to TRIP set
has been activated
Extension board not connected
properly or not supported by
program
A fault was detected in the
program.
A fault was detected during the
transfer of the parameter set to
the Drive PLC.
Parameter set does not match
Drive PLC
PAR1 is defective.
EDK10200EV3 DE/EN/FR 6.0
Remedy
Check the plug connection of bus
module FIF
Check transmitter
Increase monitoring time under
C0357/2 if necessary
Check the plug connection of bus
module FIF
Check transmitter
Increase monitoring time under
C0357/3 if necessary
Check whether bus terminator is
available
Shield control of the cables
Check PE connection
Check bus load, reduce the baud
rate, if necessary
Check external encoder
Contact Lenze
Check plug connection
Check if the Extension Board is
supported by the operating
system
Send the Drive PLC with the data
set (on diskette) to Lenze.
Correct the parameter set
Contact Lenze
Repeat data transfer or load Lenze
setting
Contact Lenze
L