Initial Setting - Clatronic MC 1020 DVD Bedienungsanleitung

Initial Setting

2. Audio setup
Audio Setup Page
Speaker Setup
SPDIF Setup
Equalizer
3D processing
MAIN PAGE
2.1 SPEAKER SETUP - it is used to set the speaker
DOWNMIX mode
Options: LT/RT-Left/Right mix mode
STEREO - Select this option if you don't
Have a 5.1 channels amplifier.
Front Speaker
Options: Large- select this option to increase the front
speaker's volume.
Small- select this option to decrease the front
speaker's volume.
2.2 SPDIF SETUP
2.2.1 SPDIF OUTPUT - digital outputs code format
Options: OFF/RAW/PCM/MANUAL
If MANUAL is selected, the options for CD,DOLBY
DIGITAL DTS, MPEG, PCM CHANNEL can be
selected individually. Otherwise, they will output
At the same format:RAW or PCM.
Recommended settings:
SPDIF OUTPUT: SPDIF OFF
(if you are not connecting to an amplifier via
Digital output)
SPDIF OUTPUT: SPDIF/RAW
(Used in general home theater,select this can output
5.1 channel)
SPDIF OUTPUT: SPDIF/PCM
(select this it can only output 2 channel,but you will
get high quality audio)
2.2.2 LPCM OUT - set bit-rate of coaxial and optical output
Options: 96K/48K
(If you are connecting to an amplifier via digital output
please reference your digital amplifier manual before
you select this option)
3. Video setup
Video Setup Page
TV TYPE
TV Output
3.1 TV TYPE
Options: PAL/MULTI/NTSC
3.2 TV OUTPUT
Options: CVBS/RGB
CVBS = Composite output
RGB = RGB output
Outputs levels
4. Preference setup
The first Power on this set by press power button on the
front plane without placing any disc on this tray, press
setup button, then you can enter the Preference Page by
pressing navigate button .
Preference Page
PBC
Audio
Subtitle
Disc Menu
Parental
Default
4.1 PBC - select PlayBack Control for VCD
Options: On/Off
(Recommended setting: ON)
4.2 AUDIO - select preferred audio language.
(DVD only - need disc software support)
4.3 SUBTITLE - select preferred subtitle language.
(DVD only - need disc software support)
4.4 DISC MENU - select preferred disc menu language.
(DVD only - need disc software support)
4.5 PARENTAL - select rating levels. You must set
PASSWORD MODE OFF to enable this selection.
(DVD only - need disc software support)
4.6 DEFAULT - Reset to factory settings
5. Password Setup
Password Setup
Parental Control
Password Change
Level Set
5.1 Parental Control
Options: ON/OFF
5.2 Password Change
Option:Change
Select to change password, a form as below will show
on the screen.
Old Password
New Password
Confirm PWD
Procedure to change password:
1) Enter old password in the Old Password row
2) Enter new password in the New Password row
3) Enter the new password again in the Confirm PWD row
You may reset the password if you forget the old password
by using the supervisor password: 1379
51
OK