Installation Guide; System Overview - Danfoss TP7000 Series Installationsanleitung

1.0 Installation Guide

Please Note:
This product should only be installed by a qualifi ed electrician or
competent heating installer and should be in accordance with the
current edition of the IEEE wiring regulations.

2.0 System Overview

GB
F
Thermostat Features
D
Power supply
ES
Memory backup
DK
Switching action of output
relay
Switch rating of relay contact,
NL
voltage and current
Transmitter frequency
I
(RF only)
Transmitter range
(RF only)
GR
Rated Impulse Voltage
Dimensions (mm)
PL
Ball Pressure Test
Temperature Range
LT
Design Standard
Control Pollution Situation
CZ
Time accuracy
Temperature accuracy
HR
*1: Unit must powered up for 6 days to charge cell before full back-up is available
Important note RF products: Ensure that there are no large metal
objects, such as boiler cases or other large appliances, in line of
sight between the transmitter and receiver as these will prevent
communication between thermostat and receiver.
4
TP7000
TP7000-RF
TP7000A
2 x AA/MN1500/LR6
alkaline batteries
Capacitor during
battery change for 1
minute
N/A
N/A 3(1) A, 10-230 volts
433.92 MHz
30m max.
N/A
138 wide x 88 high x 28 deep
5-30°C
EN 60730-2-7 (EN300220 for RF)
Degree 2
± 1 min.
TP7000-M
TP7000-M 24
TP7000-MA
230v, 50 Hz 24v, 50 Hz
Rechargable cell, 24 hrs (*1)
1 x SPDT, Type 1B
N/A
N/A
2.5Kv
75°C
±1°C
TP7000 RANGE