SilverCrest STV 30 A1
7. Before initial use
7.1 Unpacking
Take the product out of the packaging.
Completely remove all packaging materials.
Check the package contents for completeness. Contact Service immediately in case of
missing components.
7.2 Assembly
Insert the base (10) into the motor unit (8). Now fasten the base to the motor unit using the
four screws provided (11).
Screw the protective grille nut (5) anti-clockwise from the motor unit (8).
Attach the rear protective grille (6) to the motor unit (8). To do this, push the two narrow slots
on the rear protective grille (6) onto the studs on the motor unit (8). Make sure that the
handle (7) on the rear protective grille (6) is pointing upwards.
Fasten the rear protective grille (6) to the motor unit (8) using the protective grille nut (5). To
do this, tighten the protective grille nut (5) clockwise.
Remove the thread cover from the drive shaft of the motor unit (8). Then attach the rotor
blade (4) to the motor unit (8). Ensure that the recess on the rotor blade (4) holds the prong
of the motor unit drive shaft (8).
Fasten the rotor blade (4) to the motor unit (8) using the rotor blade nut (3). To do this,
tighten the rotor blade nut (3) anti-clockwise.
Remove the nut (13) and the screw (14) from the front protective grille (1).
Hang the front protective grille (1) on the rear protective grille (6). Make sure the hole in the
front protective grille (1) lines up with the hole in the rear protective grille (6).
Push the screw provided (14) through the holes in the front (1) and rear (6) protective grilles
and fasten this in place using the nut (13). Then close the hinges (2) on the front protective
grille (1) so that they clasp the edge of the rear protective grille (6).
24 – English