Silvercrest STV 30 A1 Bedienungsanleitung Seite 23


Do not use the product if the plug or the connecting cable
are damaged, if it does not operate as intended, if it has
been dropped on the floor or in water or if it exhibits any
other damage. In such cases, contact a qualified
specialist for repair.

Only connect the plug to a socket that has been properly
installed, is easily accessible and the mains voltage of
which corresponds with the information specified in the
'Technical data' section. The socket must continue to be
easily accessible after the plug has been connected.

Ensure that the connecting cable cannot be damaged by
sharp edges or hot surfaces.

When using the product, ensure that the connecting
cable is not jammed or squashed.

The product is also not fully disconnected from the power
supply once it has been switched off. Remove the plug
from the socket to fully disconnect it from the power
supply. Always pull at the plug to remove it from the
socket; never pull on the cable.

Remove the plug from the socket
o if a fault occurs,
o if you are not using
o
during assembly,
o before cleaning the product
o during thunderstorms.
the product,
and
SilverCrest STV 30 A1
English – 21