Siemens SITRANS F series Betriebsanleitung Seite 30

Connecting
3.3 Navigating the Menu
Electrical Shock Hazard
Certain parts inside the device carry dangerous high voltage that may lead to fire, electric
shock or serious injury.
The transmitter must be grounded and the top cover closed before applying power to the
device.
1. Connect the power cables to the appropriate power source (90-240 VAC @ 50/60 Hz or
9-36 VDC). Close top cover.
2. Apply power.
3. Within 10 seconds of power-up the transmitter main display will become active and a
typical Siemens graphic will appear. The screen also identifies the software version of the
unit as shown below.
4. Press the <MENU> key and the Main Menu will appear. (Language selection is not on
Version 3 op systems.)
28
WARNING
①
Software Version (xx.xx.xx)
FUS1010 IP65 NEMA 4X & IP66 NEMA 7 Quick Start
Operating Instructions, 07/2014, A5E03086486-AD